|
Growing Medias
| |
LOW WATT PROPAGATION MATS
The economical way to germinate seeds and propagate cuttings.
1. Energy Efficient
This Low Watt Propagation Mat uses 20 watts of electric power per square foot of area
covered. This means you can cover a larger propagating area with less power required than
with electric cables or old higher wattage mats. The Low Watt Propagation Mat uses less
than 5 kilowatt hours per day if it runs continuously.2. Uniform Heat
Distribution
There is absolute uniformity of heat across the mat, because it is a continuous sheet
heater, not coiled wires imbedded in a mat.
3. Simple Set Up
The Low Watt Propagation Mat is designed to raise the temperature of the growing media by
as much as 20° F. Place the mat on top of a wooden table or other insulating board
material. Place the sensing bulb of your thermostatic control about
3/4" below the surface of your seed in the growing media. Cover your propagation
setup with Fly-Barr insect barrier to hold in the heat and moisture for
better germination. If germinating in the greenhouse, it is best to shade the area so the
sun won’t cause excessively high temperatures under this cover. Locate the
mat in an area that is within 15o of your target temperature for best results.
4. Easily Moved
Your Low Watt Propagation Mat is lightweight and can easily be moved from one propagating
area to another or the larger mats can be rolled up and stored away. Has a 90 day
manufacturers warranty.
A $5.00 "Drop
Ship" Charge Will Be Added By
The Manufacturer To All Orders.
Items Are Always Shipped Direct. |
| Part #. |
Size |
Weight |
Watts (120V) |
Price |
- |
 |
| 5E158 |
22" x 44" |
2.5# |
160 |
$72.95 |
 |
| 5E159 |
22" x 14" |
1# |
40 |
$42.95 |
|
| 5E160 |
22" x 96" |
5# |
320 |
$114.95 |
|
(Thermostatic Control not included)
(We Strongly Urge You To Get A Thermostatic Controller. The Mat Could
Burn Up Without One.)
AUTOMATIC THERMOSTATIC CONTROLS
| ** Attempting to germinate seed at low or high
temperatures can seriously affect the germination percentage and the length of time
necessary to produce a good quality seedling. No one can afford this
high loss in germination, not just the cost of seed, but the loss of time, energy, labor,
space and maybe even a customers. ** 1. Place the temperature sensing
bulb in the media, approximately 3/4" below the seeds.
2. Set the thermostat dial to the temperature you wish to maintain.
3. Place the thermostat out of the way of mist systems and puddles of water.
4. Plug in up to 4 propagation mats to the thermostatic control.
5. Plug the thermostatic control into a 120 volt AC outlet making sure the
cord does not rest in a puddle of water.
6. Indicator light will glow when the mats are calling for heat.
7. Comes with a 90 day manufacturers warranty.
8. 5E 161 will control 4 mats. 5E162 controls 1 mat. A $5.00 "Drop
Ship" Charge Will Be Added By
The Manufacturer To All Orders.
Items Are Always Shipped Direct. |
5E161 Shown (Controls 4 Mats)
|
| Part No. |
Maximum Capacity |
Weight |
Range 1° Diff. |
Price |
- |
| 5E161 |
2000 Watts |
1# |
60°-100° |
$79.95 |
|
| 5E162 |
1000 Watts |
1# |
60°-100° |
$56.95 |
|
PROPAGATION FLATS
7W031 and 7W032 (F1020) flats measure 20.56" x 10.19" x 2.31" inside. These
flats will hold 52 of the 2" net pots for germination, or one flat of Horticubes.
Always water seedlings from the top to reduce the wicking that takes place during
evaporation. |
7W031 Shown (With Holes)
|
| Part # |
Supplier # |
Description |
Ship Weight |
1 case |
5 cases/case |
- |
| 7W031 |
F1020 |
Flat w/ holes; 100/case |
45# |
$129.95 |
$121.95 |
|
| 7W032 |
F1020 |
Flat w/o holes;100/case |
45# |
$99.95 |
$88.95 |
|
NET POTS
& SLIT POTS
 |
The sides and base are slit to allow root development to take
place in all directions. They are used to start seedlings which will then be transplanted
to the growing system. Transplant shock is greatly reduced as the young plant and net pot
are transferred to the growing system as a unit. The plant is NOT removed
from the net pot. |
| Part No. |
Dia. |
Height |
Weight |
Pots per/case |
Each |
1-4 cases |
5-9 cases |
- |
|
These are Net Pots. |
| 5W559 |
2.0" |
2" |
25.3# |
4250 |
$0.20 |
$147.95* |
$137.95* |
|
| 5W557 |
3.0" |
3 1/8" |
18.0# |
1400 |
$0.35 |
$165.00* |
$154.00* |
|
|
These are Slit Pots. |
| 5W580 |
2.125" |
2" |
33.3# |
4081 |
N / A |
$149.00 |
|
(* Price per case)
OASIS HORTICUBES
| This low density foam block is formulated for seed
germination with crops such as lettuce, tomatoes and spinach. The blocks should be
separated within a day or two of seed germination to keep the roots separated. Prior to or
immediately after sowing seed in the HORTICUBES, the product should be given a heavy
watering. Following this initial watering, normal watering procedures are
recommended. DO NOT sow seed in a dry sheet of foam and then store the material
prior to placement in the germination environment as damage to the seed may occur.
Hydro-Gardens' recommends filling the hole with vermiculite, and covering
the slabs with Fly-Barr insect barrier for moisture retention. Since the
medium contains no nutrients, it is necessary to begin a regular fertilization program as
soon as the cotyledon leaves develop. |
Quantity
|
Item # 5E163 1" X 1" X 1.5"
1620/Case |
Item # 5E164 1" X 1" X 1.5"
3240/Case |
Item # 5E166 Thin-Cut
5520/Case |
Item#
5E167 1" X
1.25" X 1.5"
2080/Case |
Item# 5E165 1.5" X 1.5" X 1.5"
1000/Case |
| 1-4 cases |
$67.95 |
$113.95 |
$101.95 |
$120.95 |
$105.95 |
| 5-9 cases |
- |
$110.95 |
$98.95 |
$117.95 |
$101.95 |
| 10+ cases |
- |
$107.95 |
$96.50 |
$113.50 |
$99.95 |
| - |
|
|
|
|
|
(prices are per case)
5E164, 5E165, 5E166 & 5E167 will ship
Factory Direct - Freight should be about $25 - $30 per
case.
On any shipment of 35 cases or more, freight is paid.
** For UPS Shipments, items 5E164, 5E165,
5E166 & 5E167
weight is figured as dimensional weight.
|
|
Oasis Rootcubes® Growing Medium
provides an excellent starting environment for vegetative plant cuttings
being rooted by the greenhouse propagator, large or small. It's unique
open celled design and water-absorbing capacity provides for the optimal
balance of air/water exchange necessary for root stimulation. Upon
receipt, Rootcubes® are sterile, free of pathogenic organisms, and
require no further sterilization. Rootcubes® medium also provides a
safe, efficient, shipping system for the propagator.
5E170 will ship
Factory Direct - Freight should be about $25 - $30 per
case.
** For UPS Shipments, items 5E170 weight is figured as
dimensional weight.
|
| Quantity |
Item #
5E170 1" X 1" X 1.5"
1000/Case |
| 1-4 cases |
$90.95 |
| 5-9 cases |
$87.95 |
| 10+ cases |
$85.95 |
| - |
|
POLY GROWBAGS for the TOP SPRAY
SYSTEM
| All bags are made form a specially formulated plastic
that provides for a longer life than any other on the market. All upright bags
are fluted with pre-punched drainage holes and easily stand upright when
filled with media. These bags are excellent for bedding plants, tree seedlings,
tomatoes, bell peppers, cucumbers, etc. Cost studies have proven it is less
expensive to use bags and throw them away than to wash and reuse pots. Please order in
case quantities. Other size bags are available in minimum size quantities of 10,000. Please
call for a quote. |
|
|
